Motor Vehicle Safety Regulations

Version of section 6.2 from 2006-03-22 to 2008-09-16:

  •  (1) Every incomplete vehicle manufacturer shall apply to every incomplete vehicle it manufactures an information label that displays the following:

    • (a) a statement, in both official languages, that the vehicle is an incomplete vehicle;

    • (b) the name of the incomplete vehicle manufacturer;

    • (c) the month and year the incomplete vehicle manufacturer performed its last manufacturing operation on the incomplete vehicle;

    • (d) the vehicle identification number;

    • (e) the GVWR intended for the vehicle when it is a completed vehicle, expressed in kilograms, clearly identified by the words “Gross Vehicle Weight Rating” and “Poids nominal brut du véhicule” or the abbreviations “GVWR” and “PNBV”;

    • (f) the GAWR, expressed in kilograms, intended for each axle of the vehicle when it is a completed vehicle, listed in order from front to rear and clearly identified by the words “Gross Axle Weight Ratings” and “Poids nominal brut sur l’essieu” or the abbreviations “GAWR” and “PNBE”, except that

      • (i) the GAWR for consecutive axles that have identical GAWRs when equipped with tires that have the same designated tire size may be stated once followed by the words “each” and “chacun”, and

      • (ii) the information need not appear on the label if it is set out on the placard referred to in subsection 110(5) of Schedule IV or on the label referred to in subsection 120(14) of Schedule IV; and

    • (g) in the case of a vehicle manufactured in Canada for sale in Canada, a drawing of at least 20 mm in diameter depicting the national safety mark set out in Schedule I and showing in its centre, in figures of at least 2 mm in height, the authorization number assigned by the Minister to the company under section 3.

  • (2) Subject to subsection (3), the information label shall be applied

    • (a) to the hinge pillar, door latch post or the door edge that meets the door latch post next to the driver’s seating position;

    • (b) to the left side of the instrument panel or the inward-facing surface of the door next to the driver’s seating position, if it is impracticable to apply the label in accordance with paragraph (a); or

    • (c) to a conspicuous and readily accessible location, if it is impracticable to apply the label in accordance with paragraph (a) or (b) or if the vehicle does not have the components described in paragraph (a) or (b).

  • (3) In the case of a stripped or cowl chassis, the information label may be applied to a conspicuous and readily accessible location on the steering column.

  • (4) The drawing referred to in paragraph (1)(g) may be displayed on a label applied to the vehicle beside the incomplete vehicle manufacturer’s information label.

  • SOR/2002-55, s. 5;
  • SOR/2005-342, s. 2.
Date modified: